| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix immediate JMP JEQ/JNE on MIPS32
An addu instruction was emitted instead of addiu, causing the immediate
value 1 to be interpreted as register $at. This made the comparison
result invalid when the immediate operand was negative. Note that $at
is mapped to BPF_REG_AX, which is used for constant blinding.
Fix the instruction to use the immediate form.
Found with test_bpf on MIPS32r1 emulated by QEMU. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ipv6: keep room for the mac header in dst_dev_overhead()
The seg6, ioam6 and rpl lwtunnels size their skb_cow_head() request as
the length they are about to push plus dst_dev_overhead(), then push the
new headers and rebuild the mac header below them with
skb_mac_header_rebuild(). That rebuild needs skb->mac_len of headroom,
but dst_dev_overhead() leaves LL_RESERVED_SPACE() of the egress device,
16 bytes for plain Ethernet.
Where the mac header is longer than that, as it is on ingress through a
VLAN device with reorder_hdr off, the rebuild runs out of room:
skb_set_mac_header(skb, -skb->mac_len) computes a negative offset,
stores it unchecked in the u16 skb->mac_header, and the memmove that
follows writes skb->mac_len bytes about 64 KB past skb->head.
Forwarding plain ping6 traffic through such a device reproduces it on
all five seg6 encapsulation modes and on the rpl and ioam6 inline paths;
skb->mac_header comes back as 65534 on a 704-byte head.
Return the larger of the two. The helper already returns skb->mac_len
when it has no dst, so this only makes the other branch agree, and it
covers every caller rather than each call site in turn. |
| In the Linux kernel, the following vulnerability has been resolved:
nfc: port100: reject frames whose declared length exceeds the received data
port100_recv_response() passes the URB transfer buffer to
port100_rx_frame_is_valid(), which checksums le16_to_cpu(frame->datalen)
bytes of frame->data. datalen is a 16-bit field supplied by the device
and is never checked against the number of bytes actually received
(urb->actual_length), so a device reporting a datalen larger than the
received frame makes port100_data_checksum() read out of bounds past the
transfer buffer.
Reject a response whose declared frame size does not fit the received
length before validating it.
Found by 0sec (https://0sec.ai) using automated source analysis; the
missing bound is evident from source. Compile-tested. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sock: validate event length before filtering
is_filtered_packet() reads the event code from skb->data[0] without first
checking that the skb is nonempty. When an opcode filter is configured,
it also reads the command opcode at offsets 3 or 4 without checking that
a Command Complete or Command Status event is long enough.
hci_send_to_sock() invokes the filter before hci_event_packet() validates
the event header. A malformed event supplied by a controller or a vhci
device can therefore cause an out-of-bounds read.
Keep the unmasked event code for the opcode checks. The masked value is
needed for the 64-bit event bitmap, but using it to identify command events
aliases event codes above 0x3f. In particular, Synchronous Train Complete
(0x4f) was treated as Command Status (0x0f) even though its payload has no
opcode.
Reject actual command events that are too short for the field being
inspected. A truncated command event cannot match a configured opcode. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sock: reject out-of-range OCF values
The raw HCI socket security filter has 128 OCF bits per supported OGF,
but masks the 10-bit OCF with 127 before looking up the command. An
unprivileged socket can therefore submit a reserved OCF that aliases an
allowlisted command modulo 128.
A conforming controller should reject reserved opcodes. Nevertheless,
the security decision must apply to the opcode that will actually be
sent, especially since controller-specific behavior is outside the host
stack's control.
Reject OCF values that cannot be represented by the security filter
instead of aliasing them onto an unrelated command. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: validate frame length before control and FCS access
l2cap_data_rcv() unpacks either a two-byte or four-byte control field
without first ensuring that it is present. A short ERTM or streaming-mode
frame can therefore cause an out-of-bounds read.
There is a second short-frame case when CRC16 is enabled. After the
control field is pulled, l2cap_check_fcs() subtracts two from skb->len
without checking it. If fewer than two bytes remain, the subtraction
wraps; skb_trim() leaves the buffer unchanged and the subsequent FCS
load reads past the logical end of the frame.
Validate that the frame contains both its control field and, when
enabled, its FCS before either field is accessed. |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: fix wild memcpy access when formatting ondisk rtrefcount btree roots
LOLLM noticed that the inode btree root formatting methods copy too many
bytes -- there's only one set of keys in node blocks, not two. This
causes memory corruption of whatever's beyond the buffers. |
| Out-of-bounds read in DNS Server allows an authorized attacker to disclose information over a network. |
| Out-of-bounds read in DNS Server allows an authorized attacker to disclose information over a network. |
| ip-address before 10.7.4 allows a denial of service (CPU consumption from quadratic complexity, and application stall) via many % characters in input reaching a function call that uses the Address6 constructor. |
| In wlan AP driver, there is a possible out of bounds write due to an incorrect bounds check. This could lead to local escalation of privilege if a malicious actor has already obtained the System privilege (when OceReducedNeighborReport is disabled). User interaction is not needed for exploitation. Patch ID: WCNCR00441511; Issue ID: MSV-4140. |
| Out-of-bounds read in Windows Partition Management Driver allows an unauthorized attacker to execute code over a network. |
| An issue was discovered in HAProxy before 3.3.6. The HTTP/3 parser does not check that the received body length matches a previously announced content-length when the stream is closed via a frame with an empty payload. This can cause desynchronization issues with the backend server and could be used for request smuggling. The earliest affected version is 2.6. |
| Heap-based buffer overflow in Windows Container Isolation FS Filter Driver (unionfs.sys) allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Hyper-V allows an authorized attacker to disclose information over a network. |
| A weakness has been identified in liftoff-sr CIPster 1802525be27d33e19a9a83c163e331a1d13b1892. This affects the function CipConnMgrClass::forward_open of the file cipconnectionmanager.cc of the component ForwardOpen Handler. Executing a manipulation of the argument product_code_ can lead to out-of-bounds read. It is possible to launch the attack remotely. The exploit has been made available to the public and could be used for attacks. This patch is called ea870a274bf68dfaa3f511f20e2fff6778fb7b74. A patch should be applied to remediate this issue. |
| Capstone is a disassembly framework. In 6.0.0-Alpha9 and earlier, Capstone's arch/SH/SHDisassembler.c SH floating-point decoders such as opFADD, opFMUL, and opFSUB call set_reg() and set_reg_n() using sh_info.op.op_count without checking the fixed-size operands[] array. Repeated crafted instructions processed through cs_disasm_iter() or cs_disasm() with CS_ARCH_SH, CS_MODE_SH2A or CS_MODE_SH4A, CS_MODE_SHFPU, and CS_OPT_DETAIL can increment the operand count beyond the 176-byte sh_info allocation and perform a four-byte heap buffer overflow write. The corruption can crash the process and may enable code execution depending on heap layout. This issue is fixed in version 6.0.0-Alpha10. |
| Capstone is a disassembly framework. In 6.0.0-Alpha9 and earlier, Capstone's arch/SH/SHDisassembler.c sh_disassemble() function computes an idx value from a raw 16-bit instruction without ensuring it is within the active mode-specific decode[] function-pointer table. An application using CS_ARCH_SH with CS_MODE_SH2A or CS_MODE_SH4A and CS_MODE_SHFPU can pass crafted bytecode through cs_disasm_iter() or cs_disasm(), causing the decode[idx] test to read outside the table and terminate the process with a segmentation fault. No code execution or information disclosure was demonstrated. This issue is fixed in version 6.0.0-Alpha10. |
| IBM Concert 1.0.0 through 2.0.0 could allow a local user to forge log files to impersonate other users or hide their identity due to improper neutralization of output. |
| Format Plugins versions 1.1.1 and earlier are affected by an Out-of-bounds Read vulnerability that could lead to memory exposure. An attacker could leverage this vulnerability to access sensitive memory information. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
