| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: reject zero shift in nft_bitwise
Reject zero shift operands for nft_bitwise left and right shift
expressions during initialization.
The carry propagation logic computes the carry from the adjacent 32-bit
word using BITS_PER_TYPE(u32) - shift. A zero shift operand turns this
into a 32-bit shift, which is undefined behaviour.
Reject zero shift operands in the control plane, alongside the existing
check for values greater than or equal to 32, so malformed rules never
reach the packet path. |
| In the Linux kernel, the following vulnerability has been resolved:
md/md-llbitmap: raise barrier before state machine transition
Move the barrier raise operation before calling llbitmap_state_machine()
in both llbitmap_start_write() and llbitmap_start_discard(). This
ensures the barrier is in place before any state transitions occur,
preventing potential race conditions where the state machine could
complete before the barrier is properly raised. |
| In the Linux kernel, the following vulnerability has been resolved:
media: rc: igorplugusb: heed coherency rules
In a control request, the USB request structure
can be subject to DMA on some HCs. Hence it must obey
the rules for DMA coherency. Allocate it separately. |
| In the Linux kernel, the following vulnerability has been resolved:
zram: do not forget to endio for partial discard requests
As reported by Qu Wenruo and Avinesh Kumar, the following
getconf PAGESIZE
65536
blkdiscard -p 4k /dev/zram0
takes literally forever to complete. zram doesn't support partial
discards and just returns immediately w/o doing any discard work in such
cases. The problem is that we forget to endio on our way out, so
blkdiscard sleeps forever in submit_bio_wait(). Fix this by jumping to
end_bio label, which does bio_endio(). |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: control: Validate buf_len before strnlen() in snd_ctl_elem_init_enum_names()
snd_ctl_elem_init_enum_names() advances pointer p through the names
buffer while decrementing buf_len. If buf_len reaches zero but items
remain, the next iteration calls strnlen(p, 0).
While strnlen(p, 0) returns 0 and would hit the existing name_len == 0
error path, CONFIG_FORTIFY_SOURCE's fortified strnlen() first checks
maxlen against __builtin_dynamic_object_size(). When Clang loses track
of p's object size inside the loop, this triggers a BRK exception panic
before the return value is examined.
Add a buf_len == 0 guard at the loop entry to prevent calling fortified
strnlen() on an exhausted buffer.
Found by kernel fuzz testing through Xiaomi Smartphone. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Inject #UD for INVLPGA if EFER.SVME=0
INVLPGA should cause a #UD when EFER.SVME is not set. Add a check to
properly inject #UD when EFER.SVME=0.
[sean: tag for stable@] |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: split transactions in dio completion to avoid credit exhaustion
During ocfs2 dio operations, JBD2 may report warnings via following
call trace:
ocfs2_dio_end_io_write
ocfs2_mark_extent_written
ocfs2_change_extent_flag
ocfs2_split_extent
ocfs2_try_to_merge_extent
ocfs2_extend_rotate_transaction
ocfs2_extend_trans
jbd2__journal_restart
start_this_handle
output: JBD2: kworker/6:2 wants too many credits credits:5450 rsv_credits:0 max:5449
To prevent exceeding the credits limit, modify ocfs2_dio_end_io_write() to
handle extents in a batch of transaction.
Additionally, relocate ocfs2_del_inode_from_orphan(). The orphan inode
should only be removed from the orphan list after the extent tree update
is complete. This ensures that if a crash occurs in the middle of extent
tree updates, we won't leave stale blocks beyond EOF.
This patch also changes the logic for updating the inode size and removing
orphan, making it similar to ext4_dio_write_end_io(). Both operations are
performed only when everything looks good.
Finally, thanks to Jans and Joseph for providing the bug fix prototype and
suggestions. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: nSVM: Avoid clearing VMCB_LBR in vmcb12
svm_copy_lbrs() always marks VMCB_LBR dirty in the destination VMCB.
However, nested_svm_vmexit() uses it to copy LBRs to vmcb12, and
clearing clean bits in vmcb12 is not architecturally defined.
Move vmcb_mark_dirty() to callers and drop it for vmcb12.
This also facilitates incoming refactoring that does not pass the entire
VMCB to svm_copy_lbrs(). |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: qat - fix IRQ cleanup on 6xxx probe failure
When adf_dev_up() partially completes and then fails, the IRQ
handlers registered during adf_isr_resource_alloc() are not detached
before the MSI-X vectors are released.
Since the device is enabled with pcim_enable_device(), calling
pci_alloc_irq_vectors() internally registers pcim_msi_release() as a
devres action. On probe failure, devres runs pcim_msi_release() which
calls pci_free_irq_vectors(), tearing down the MSI-X vectors while IRQ
handlers (for example 'qat0-bundle0') are still attached. This causes
remove_proc_entry() warnings:
[ 22.163964] remove_proc_entry: removing non-empty directory 'irq/143', leaking at least 'qat0-bundle0'
Moving the devm_add_action_or_reset() before adf_dev_up() does not solve
the problem since devres runs in LIFO order and pcim_msi_release(),
registered later inside adf_dev_up(), would still fire before
adf_device_down().
Fix by calling adf_dev_down() explicitly when adf_dev_up() fails, to
properly free IRQ handlers before devres releases the MSI-X vectors. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: nSVM: Always use NextRIP as vmcb02's NextRIP after first L2 VMRUN
For guests with NRIPS disabled, L1 does not provide NextRIP when running
an L2 with an injected soft interrupt, instead it advances the current RIP
before running it. KVM uses the current RIP as the NextRIP in vmcb02 to
emulate a CPU without NRIPS.
However, after L2 runs the first time, NextRIP will be updated by the CPU
and/or KVM, and the current RIP is no longer the correct value to use in
vmcb02. Hence, after save/restore, use the current RIP if and only if a
nested run is pending, otherwise use NextRIP. Give soft_int_next_rip the
same treatment, as it's the same logic, just for a narrower use case.
[sean: give soft_int_next_rip the same treatment] |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: ctxfi: Add fallback to default RSR for S/PDIF
spdif_passthru_playback_get_resources() uses atc->pll_rate as the RSR
for the MSR calculation loop. However, pll_rate is only updated in
atc_pll_init() and not in hw_pll_init(), so it remains 0 after the
card init.
When spdif_passthru_playback_setup() skips atc_pll_init() for
32000 Hz, (rsr * desc.msr) always becomes 0, causing the loop to spin
indefinitely.
Add fallback to use atc->rsr when atc->pll_rate is 0. This reflects
the hardware state, since hw_card_init() already configures the PLL
to the default RSR. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: fix missing brelse() in ext4_xattr_inode_dec_ref_all()
The commit c8e008b60492 ("ext4: ignore xattrs past end")
introduced a refcount leak in when block_csum is false.
ext4_xattr_inode_dec_ref_all() calls ext4_get_inode_loc() to
get iloc.bh, but never releases it with brelse(). |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: nSVM: Triple fault if restore host CR3 fails on nested #VMEXIT
If loading L1's CR3 fails on a nested #VMEXIT, nested_svm_vmexit()
returns an error code that is ignored by most callers, and continues to
run L1 with corrupted state. A sane recovery is not possible in this
case, and HW behavior is to cause a shutdown. Inject a triple fault
instead, and do not return early from nested_svm_vmexit(). Continue
cleaning up the vCPU state (e.g. clear pending exceptions), to handle
the failure as gracefully as possible.
From the APM:
Upon #VMEXIT, the processor performs the following actions in order to
return to the host execution context:
...
if (illegal host state loaded, or exception while loading host state)
shutdown
else
execute first host instruction following the VMRUN
Remove the return value of nested_svm_vmexit(), which is mostly
unchecked anyway. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: algif_aead - snapshot IV for async AEAD requests
AF_ALG AEAD AIO requests currently use the socket-wide IV buffer during
request processing. For async requests, later socket activity can
update that shared state before the original request has fully
completed, which can lead to inconsistent IV handling.
Snapshot the IV into per-request storage when preparing the AEAD
request, so in-flight operations no longer depend on mutable socket
state. |
| In the Linux kernel, the following vulnerability has been resolved:
net: qrtr: ns: Limit the maximum number of lookups
Current code does no bound checking on the number of lookups a client can
perform. Though the code restricts the lookups to local clients, there is
still a possibility of a malicious local client sending a flood of
NEW_LOOKUP messages over the same socket.
Fix this issue by limiting the maximum number of lookups to 64 globally.
Since the nameserver allows only atmost one local observer, this global
lookup count will ensure that the lookups stay within the limit.
Note that, limit of 64 is chosen based on the current platform
requirements. If requirement changes in the future, this limit can be
increased. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: stop parsing UAC2 rates at MAX_NR_RATES
parse_uac2_sample_rate_range() caps the number of enumerated
rates at MAX_NR_RATES, but it only breaks out of the current
rate loop. A malformed UAC2 RANGE response with additional
triplets continues parsing the remaining triplets and repeatedly
prints "invalid uac2 rates" while probe still holds
register_mutex.
Stop the whole parse once the cap is reached and return the
number of rates collected so far. |
| In the Linux kernel, the following vulnerability has been resolved:
net: qrtr: ns: Limit the total number of nodes
Currently, the nameserver doesn't limit the number of nodes it handles.
This can be an attack vector if a malicious client starts registering
random nodes, leading to memory exhaustion.
Hence, limit the maximum number of nodes to 64. Note that, limit of 64 is
chosen based on the current platform requirements. If requirement changes
in the future, this limit can be increased. |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix conn-level packet handling to unshare RESPONSE packets
The security operations that verify the RESPONSE packets decrypt bits of it
in place - however, the sk_buff may be shared with a packet sniffer, which
would lead to the sniffer seeing an apparently corrupt packet (actually
decrypted).
Fix this by handing a copy of the packet off to the specific security
handler if the packet was cloned. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: sd: fix missing put_disk() when device_add(&disk_dev) fails
If device_add(&sdkp->disk_dev) fails, put_device() runs
scsi_disk_release(), which frees the scsi_disk but leaves the gendisk
referenced. The device_add_disk() error path in sd_probe() calls
put_disk(gd); call put_disk(gd) here to mirror that cleanup. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: nSVM: Sync interrupt shadow to cached vmcb12 after VMRUN of L2
After VMRUN in guest mode, nested_sync_control_from_vmcb02() syncs
fields written by the CPU from vmcb02 to the cached vmcb12. This is
because the cached vmcb12 is used as the authoritative copy of some of
the controls, and is the payload when saving/restoring nested state.
int_state is also written by the CPU, specifically bit 0 (i.e.
SVM_INTERRUPT_SHADOW_MASK) for nested VMs, but it is not sync'd to
cached vmcb12. This does not cause a problem if KVM_SET_NESTED_STATE
preceeds KVM_SET_VCPU_EVENTS in the restore path, as an interrupt shadow
would be correctly restored to vmcb02 (KVM_SET_VCPU_EVENTS overwrites
what KVM_SET_NESTED_STATE restored in int_state).
However, if KVM_SET_VCPU_EVENTS preceeds KVM_SET_NESTED_STATE, an
interrupt shadow would be restored into vmcb01 instead of vmcb02. This
would mostly be benign for L1 (delays an interrupt), but not for L2. For
L2, the vCPU could hang (e.g. if a wakeup interrupt is delivered before
a HLT that should have been in an interrupt shadow).
Sync int_state to the cached vmcb12 in nested_sync_control_from_vmcb02()
to avoid this problem. With that, KVM_SET_NESTED_STATE restores the
correct interrupt shadow state, and if KVM_SET_VCPU_EVENTS follows it
would overwrite it with the same value. |
